Barton Mainsheet System Size 1 2:1 Cleats at 70deg on End Fittings

Barton Mainsheet System Size 1 2:1 Purchase with Cleats at 70º on End Fittings

• Pre-packaged mainsheet systems with all components required in one complete kit - sliding bolt track, traveller, end fittings, plastic end caps, pilot track and full fitting instructions.
• Travellers, end fittings and track are all extruded from top quality marine grade aluminium and finished in Barton's unique 'Spectro' grey anodised finish.
• Sliding bolt track allows for a smooth, clean profile and also make retro-fitting easier as bolts can be slid along the extrusion to match existing fastening holes.
• Available in 2:1 or 4:1 purchase systems.
• Recirculating precision ground Delrin ball system.

2:1 Purchase Kit with Cleats at 70º on end fittings;

• 1.4m (size1)/ 1.6m (size2) sliding bolt track
• Traveller car with single shackle take of
• Pair of end fittings
• Pair of plastic end caps
• Pilot track and fitting instructions

Specifications		Size 1	Size 2
Maximum Boat Size	Metres	8.5	11
	Feet	28 ½	36
Track Width		20 mm	26 mm
Track Length		1.4 m	1.6 m
Maximum Control Line Diameter		6 mm	8 mm
Safe Working Load		500 kgs	700 kgs
Fastenings Diameter		5 mm	6 mm

Important Note:
Suggested boat sizes are given as guidance only and assume a monohull with boom end sheeting, loaded vertically to the traveller. Mid-boom sheeting and severely angled take offs can impose greater loads and suitable allowances should be made for this. If at all unsure of your choice it is important to seek further advise. If you are close to the maximum boat size suggested, we would advise upgrading to the next size up. Complete pack kits are not suitable for open span applications as they require beam section track.